Te溶剂Bridgman法CdMnTe晶体核辐射探测器的制备和表征

碲锰镉(CdMnTe)作为性能优异的室温核辐射探测器材料,可用于环境监测和工业无损检测领域。本文中采用Te溶剂Bridgman法生长In掺杂Cd_0.9Mn_0.1Te晶体,制备成10 mm×10 mm×2 mm大小的室温单平面探测器,研究了该探测器对²⁴¹Am@59.5 keV γ射线源的能谱响应。通过表征红外透过率、电阻率以及探测器能谱响应等参数,综合评定了探测器用CdMnTe晶体的质量、电学和探测器性能。结果表明,晶片的红外透过率均在55%以上,最好可达到60%。采用湿法钝化,100 V偏压下的漏电流由钝化前的9.48 nA降为钝化后的7.90 nA,钝化后的电阻率为2.832×10¹⁰ Ω·cm。在-400 V反向偏压下,CdMnTe探测器对²⁴¹Am@59.5 keV γ射线源的能量分辨率在钝化前后分别为13.53%和12.51%,钝化后的电子迁移率寿命积为1.049×10^-3 cm²/V。研究了探测器的能量分辨率随电压的变化特性,当偏压≤400 V时,探测器的能量分辨率主要由载流子的收集效率决定,而当偏压>400 V时,能量分辨率由漏电流决定。本文研究结果表明,Te溶剂Bridgman法生长的CdMnTe晶体质量较好,电阻率和电子迁移率寿命积满足探测器制备需求。     

悬链线竖向集中力作用下的构形分析和张力计算

目前,悬链线在竖向集中力和均布荷载共同作用下的构形分析和受力计算的理论仍不完善。针对这一问题,通过引入悬链线的几何约束方程、力平衡方程和超越方程,建立了竖向集中力与均布荷载共同作用下的非线性方程组。采用牛顿迭代法求解方程组,得到了悬链线的构形和受力情况。为了验证理论计算的正确性,进行了算例和试验验证。结果表明,算例的计算结果与文献结论保持一致,试验测得的构形和水平张力大小与理论计算的构形和水平张力大小吻合较好。本文的理论计算可以更加简单精确地计算出悬链线在竖向集中力和均布荷载共同作用下的构形和受力情况,为实际工程提供重要的理论指导。     

Back to the future: A retrospective assessment of model‐based scenarios for the management of the shrimp fishery in French Guiana facing global change

While the number of models dedicated to predicting the consequences of alternative resource management strategies has increased, instances in which authors look back at past predictions to learn from discrepancies between these and observed developments are scarce. In the past decades, the French Guiana shrimp fishery has experienced shrimp market globalization and decreasing levels of shrimp recruitment due to environmental changes. In 2006, a bio‐economic model of this fishery was developed to simulate its possible responses to economic and environmental scenarios up to 2016. Here, we compare here these predictions to the observed trajectories. While the number of active vessels corresponds to that which was predicted, the estimated shrimp stock does not. Important driving factors had not been anticipated, including a general strike, natural disasters, and the end of the global financial crisis. These results show the importance of participative approaches involving stakeholders in the co‐construction and shared representation of scenarios. Recommendations for resource managers

• Effective fisheries resources management and a fortiori, the capacity of the fisheries to adapt to global change, requires understanding of both ecological and economics dynamics.
• The temporal trajectory of the trawling shrimp fisheries has been well monitored, and the decline of both stock and fleet is understood regarding ecological and economic changes: Changes in the environmental conditions of shrimp recruitment, and oil price increase and selling price decrease.
• However, our bio‐economic modeling work showed that, even with a good understanding of the dynamics explaining past trajectories, unpredictable events (strike, natural disasters…) have acted as other key driving factors altering the capacity of the model to represent possible futures.
• These results led us to recommend a better integration of the expertise of social and political scientists in developing models of bio‐economic systems to increase the quality of scenario predictions, and to argue for more participative approaches involving the stakeholders.

     

Development and application of chip calorimeter as an X-ray detector

Radiotherapy for cancer patients requires accurate measurement of the absorbed dose of radiation in a treatment planning step. Various types of radiation detectors are currently utilized for dose measurement. Among them, calorimeters are known to be the most precise detector for measuring absorbed dose, but their on-site application is limited by the large size of the equipment. We developed a miniaturized chip calorimeter for application as a radiation detector. The calorimetric radiation detector was built using micro/nano fabrication techniques, and consists of an SU-8 photoresist absorber and high-sensitivity vanadium oxide (VO_x) thermistors. The thermistors had a temperature resolution of 135 μK, and the calorimeter showed a thermal conductance of 11 μW/K. The detector was irradiated with various X-ray dose rates from a linear accelerator, and the absorbed dose to SU-8 was measured. The detector responses showed high linearity with dose rates, demonstrating the feasibility of the radiation detector for practical uses.     

超临界压力CO2在水平圆管内流动传热数值分析

采用SST k-w低雷诺数湍流模型对加热条件下超临界压力CO2在内径di=22.14 mm,加热长度Lh=2440 mm水平圆管内三维稳态流动与传热特性进行了数值计算.通过超临界CO2在水平圆管内的流动传热实验数据验证了数值模型的可靠性和准确性.首先,研究了超临界压力CO2在水平圆管内的流动传热特点,基于超临界CO2在类临界温度Tpc处发生类液-类气“相变”的假设,揭示了水平圆管顶母线和底母线区域不同的流动传热行为.然后,分析了热流密度qw和质量流速G对水平圆管内超临界压力CO2流动换热的影响,通过获取流体域内的物性分布、速度分布和湍流分布等详细信息,重点解释了不同热流密度qw和质量流速G下顶母线内壁温度Tw,i分布产生差异的传热机理,分析结果确定了类气膜厚度d、类气膜性质、轴向速度u和湍动能k是影响顶母线壁温分布差异的主要因素.研究结果可以为超临界压力CO2换热装置的优化设计和安全运行提供理论指导.     

晶格畸变检测仪研究碳化硅晶片中位错缺陷分布

利用晶格畸变检测仪研究了SiC晶片位错分布情况,通过对熔融KOH腐蚀后的SiC晶片进行全片或局部扫描,从而得到完整SiC晶片或局部区域的位错分布。与LEXT OLS4000 3D激光共聚焦显微镜扫描腐蚀图进行比较,晶格畸变检测仪扫描腐蚀图可以将晶片上位错腐蚀坑信息完全呈现出来,且根据腐蚀坑呈现的颜色及尺寸大小,可以分辨出三种不同类型的穿透型位错,其中黑点腐蚀坑对应螺位错,小尺寸白点腐蚀坑对应刃位错,大尺寸白点腐蚀坑对应混合型位错。采用晶格畸变测试仪研究了4英寸(101.6 mm)N型4H-SiC晶体不同生长时期的位错密度及分布情况,结果表明随着晶体生长,位错密度呈现逐渐降低的趋势,生长后期晶片的总位错密度降为生长前期晶片总位错密度的近1/3,有利于反馈位错缺陷在SiC晶体生长过程中的延伸和转化特性信息,以指导SiC晶体生长工艺改进。     

Rapid separation and simultaneous quantitative determination of 13 constituents in Psoraleae Fructus by a single marker using high‐performance liquid chromatography with diode array detection

Psoraleae Fructus is one of the most popular traditional Chinese medicines. Coumarins, flavonoids, and meroterpenes are the main contributors to the biological activity of Psoraleae Fructus. In this study, a new method for the quality control of Psoraleae Fructus was developed, through the quantitative analysis of multicomponents by single marker with diode array detector. Thirteen components, including psoralenoside, isopsoralenoside, psoralen, isopsoralen, psoralidin, neobavaisoflavone, bavachin, corylin, isobavachalcone, corylifol A, bavachinin, bavachalcone, and bakuchiol were rapidly separated and identified within 12 min by the newly developed method. The feasibility and reliability of this method were corroborated. The method was also compared to the external standard method and detection by corona charged aerosol detector. The results of percent difference (%) and cos (θ) have shown that there were no significant differences observed between the quantitative analysis of multicomponents by single marker and external standard method analyses; psoralen and isopsoralen were undetectable with the corona charged aerosol detector due to their but the sensitivity for all the compounds except bakuchiol detected by corona charged aerosol detector are higher than those obtained by diode array detector. In addition, the newly method developed was applied to the quality evaluation of Chinese patent medicines containing Psoraleae Fructus.     

A Hybrid Finite Volume Method for Advection Equations and Its Applications in Population Dynamics

We present in this article a very adapted finite volume numerical scheme for transport type‐equation. The scheme is an hybrid one combining an anti‐dissipative method with down‐winding approach for the flux (Després and Lagoutière, C R Acad Sci Paris Sér I Math 328(10) (1999), 939–944; Goudon, Lagoutière, and Tine, Math Method Appl Sci 23(7) (2013), 1177–1215) and an high accurate method as the WENO5 one (Jiang and Shu, J Comput Phys 126 (1996), 202–228). The main goal is to construct a scheme able to capture in exact way the numerical solution of transport type‐equation without artifact like numerical diffusion or without “stairs” like oscillations and this for any regular or discontinuous initial distribution. This kind of numerical hybrid scheme is very suitable when properties on the long term asymptotic behavior of the solution are of central importance in the modeling what is often the case in context of population dynamics where the final distribution of the considered population and its mass preservation relation are required for prediction. © 2017 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq 33: 1114–1142, 2017     

Simple high-performance liquid chromatography-ultraviolet method for simultaneous separation and detection of 14 bisphenol pollutants in building materials

A high-performance liquid chromatography-ultraviolet method was developed for rapidly and simultaneously analyzing novel and typical bisphenols in building materials, including bisphenol S, diphenolic acid, bisphenol F, bisphenol E, bisphenol A, bisphenol B, bisphenol AF, bisphenol AP, bisphenol C, bisphenol FL, bisphenol Z, bisphenol BP, bisphenol M, and bisphenol P. By using a Kromasil 100–5 C18 column, these bisphenols were completely separated in 40 min via gradually increasing the concentration of methanol in the mobile phase from 45 to 80% during the elution process. In particular, this method achieved the synchronous analysis of bisphenol S, diphenolic acid, bisphenol FL, bisphenol BP, and bisphenol M through HPLC, which were difficult to separate and had to be identified and detected through mass spectrometry. The limits of detection of the method ranged from 0.002 to 0.040 mg/L for these 14 bisphenols, with a precision of less than 4.9% (n = 7, c = 0.05 mg/L). The analytical results for five types of building materials (phenolic, epoxy, polycarbonate, polyester, and polysulfone resins) indicated that the proposed method is appropriated for the rapid measurement of bisphenols in real samples.     

Supercritical fluid extraction of lipids from linseed with on-line evaporative light scattering detection

Supercritical fluid extraction (SFE) is a green alternative method of extraction for neutral lipids in seeds compared to conventional methods utilizing organic solvents. In this work, a novel method where SFE is hyphenated with an evaporative light scattering detector is presented. The method was subsequently applied to determine lipid content in crushed linseed. The new method enables rapid quantification of extracted lipids as well as be ability to continuously monitor the extraction rate in real-time, thus being able to determine the time point of completed extraction.